Saving 10% off When Sign up

Menu
0

Saving 10% off When Sign up

    0

    Your Cart is Empty

    Home / Products / Upgraded Silent Board with TMC2208 Driver For Ender 5 PLUS/CR-10S/CR-X
    Upgraded Silent Board with TMC2208 Driver For Ender 5 PLUS/CR-10S/CR-X
    Upgraded Silent Board with TMC2208 Driver For Ender 5 PLUS/CR-10S/CR-X
    Upgraded Silent Board with TMC2208 Driver For Ender 5 PLUS/CR-10S/CR-X

    Upgraded Silent Board with TMC2208 Driver For Ender 5 PLUS/CR-10S/CR-X

    $84.00

    Options
    Ship from

    17 items left


    Upgraded Silent Board with TMC2208 Driver For Creality Ender 5 PLUS/CR-X 3D Printer

    This option is the separate upgraded for Ender 5 PLUS, just plug it in and you could start printing.
    Notice: This new upgraded silent mainboard does not currently come pre-installed on Ender 5 PLUS.


    Features:
    -Super Quiet and Noise Reduction. Use TMC2208 Stepper Motor Drivers, which the key component to eliminate the printer's motor when printing. 
    -Bootloader pre-installed. The firmware can be modified by ARDUINO or Cura with the USB cable.
    -Concern for safety. Thermal runaway protection is enabled, if the temperature rises out of control, the printer will stop heating and halt automatically.

     

    Support：
    - Stepper Motor Driver based on TMC2208
    - Voltage: Works on 12V and 24V

    Creality V2.2 PCB:  
    Different from the Regular V2.2 Board, in the position of the stepper motor driver chip, the resistance value is different (can be directly observed on the motherboard). 
    Conventional: R100 mute: R150

    Customer Reviews

    Based on 2 reviews
    100%
    (2)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    F
    Frank Dahl
    Great Upgrade

    I have upgraded tw Ender 5’s with Silent boards. What an improvement!

    R
    Rob
    Unbelievable difference in noise level and easy install

    I can't believe the difference in the noise level of my printer after installing this board, It really is silent other than the cooling fans. This should have been included in the printer by Creality. The install was pretty easy, just take pictures before removing plugs from the old board and put them back in the exact same spots on the new board. Be especially vigilent when moving the wires for the BLTouch as it's easy to get them wrong.

    Subscribe

    20% OFF Z1 10W