Comgrow Magnetic Honeycomb Laser Panel with Aluminum Plate For Engraver Cutter Machine

Size
from

Honeycomb cutting plate 

The laser honey comb cutting plate is a must for anyone who owns a laser engraving and cutting machine. The size of the work bed is 400*400*22mm(15.75*15.75*0.87inch)/600*590*22mm(23.6*23.2*0.87 in.) For D1, Ortur, Sculpfun, NEJE, CV-01,D1,D1 Pro, Atomstack, etc.
It helps reduce the smoke damage underneath a plank when laser cutting.

Our laser honeycomb beds are well protected against damage to the worktop. A stainless steel mat is placed under the honeycomb frame to protect the table surface from the laser beam. Allows very nice clean cuts with wood acrylic, plastic, etc.

It is compatible with almost all common diode laser engravers and CO2 laser engraving machines on the market.


Customer Reviews

Based on 9 reviews
100%
(9)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
J
James Dixon
Works well but I wish I had bought the larger size

Both it and the engraver were 400x400 but I'm new at this. If I had bought the 600x600 then the engraver would sit on the honey pad. As it is, the pad has to be moved around and I've raised the engraver so that the honeycomb pad can be moved to where it needs to go.

L
Leslie Davis
Honeycomb laser panel

I just really like it!

J
James Henderson
Honeycomb laser panel

It is the best if you have a laser you need one of these so you don't burn up the board the laser sitting on I love this it works very well...

E
Eloy B
Great but needs a few changes

Would I recommend it, ABSOLUTELY! Price and features are above average.

Its a magnetic, 8mm spaced bed. So you will be able to use magnetic holders to secure you work as well as the push-in pins that insert into the holes. Just be sure those pins you buy or make are scaled to fit the 8mm holes.

It includes a metallic sheet that goes underneath to protect your waste board from being marked while engraving. However, the bed sits directly on the metal sheet and does not allow for airflow unless you put some separators between the sheet and the bed yourself. I used some MDF scrap square in the corners until I 3D printed legs

Also there is a frame around the edge of the bed so you don't actually have a 400x400 Honeycomb bed its more like 360x360.

Also, the frame sticks up a bit (they all do, though) so if you have the Z1 5W for example and are engraving thin material like Paper or Cardboard, the module may hit the frame during homing.

D
Dennis Calleja
Honeycomb Laser Panel

Excellent quality and product. Highly recommended.

Subscribe

Over $99 Save 10% Disconut——Add to Cart